What is the most “afraid” project of the water cup factory usually?

It should be said that it is not so much the most "fearful" of the water cup factory, but it should be the most terrifying project of the water cup factory, and the most troublesome project when you see it.The editor also has a long working experience in the water cup industry.It is not an exaggeration to say that he is an old man in the water cup industry.Over the years, I have been in contact with many projects, developed many projects, and produced many projects.

Some friends will say why don't you just say that you have produced a lot of projects?There's really a lot of difference here.Some projects just stay on the design drawing, and some cannot be completed in production because of unreasonable design, and the function and purpose of the design cannot be achieved after completion;Some will have to give up due to the lack of market response after the evaluation and the high development cost.

In the development of the project, not all projects can finally be implemented.However, once the mold opening process is started, large-scale goods are basically produced.The difference is that some will do it once and some will do many batches.However, there are also many projects that can be realized in the evaluation of drawing design, and have also experienced steps such as prototype production.However, due to some later processes, the production was slow and the defective product rate was high.

Not every item, even those that are produced, is well produced.Speaking of which, the editor will tell you about the headaches of the water cup factory.

Production of special-shaped drinking glasses. As a water cup factory, try to meet the stylized production in the production of products, and have a fixed amount of satisfaction, so that the factory can squeeze out some profits through scientific management and control in the meager profits.The special-shaped water cup is a headache for many water cup factories.

First of all, the production of special-shaped water cups requires manual operations, which will result in low production efficiency.Secondly, the quality of the products produced is not uniform, and many special-shaped water cups must be poorly polished.Even manual work cannot achieve complete polishing in a short period of time, and it is not possible to use fully automatic machinery.Under such circumstances, many factories are reluctant to undertake even projects with high profits due to the substantial increase in the rate of defective products.

The surface of the water cup needs to be assembled by welding multiple times.The most likely document for welding assembly is the appearance of trachoma caused by welding, which is a defective product for later vacuuming.Secondly, the more components are welded, the more difficult it is to polish, and the more difficult it is to do surface treatment, including pattern printing, spraying, etc.

Then there is the square product.Recently, some square thermos cups have appeared in the market, but only the bottom of the thermos cup is square, and the position of the cup mouth is very small.This is because the way of square welding is completely different from that of circular welding, and the defective product rate of square welding after polishing is much higher than that of circular welding.

As I mentioned earlier, the square thermos cup is easily deformed by vacuuming.In order to ensure no deformation, it is usually to increase the thickness of the product material.However, for stainless steel water cups, the thicker the material, the worse the thermal insulation effect will be, so the water cup products that exceed the reasonable requirements of the process are a headache for the water cup factory.

Finally, the editor will say one more thing, a product that needs to be processed repeatedly in the same process will give the water cup factory a headache.